prohibited substance is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Last reviewed on 2025-12-15. Where a claim depends on a specific study, the study is described rather than over-claimed.
No major regulatory agency has approved TB-500 for therapeutic use, and it holds no pharmacopoeial monograph. The name appears on the World Anti-Doping Agency prohibited list within the class covering peptide hormones, growth factors, and related substances. Detection in doping control relies on mass spectrometric methods applied to urine, often after preparation steps that concentrate the analyte. Discussion of TB-500 therefore clusters in biochemistry, sports medicine, and anti-doping literature rather than in registered clinical trials.
TB-500 is a synthetic peptide preparation marketed under a name derived from thymosin beta-4, a 43-residue actin-binding protein first isolated from thymus tissue. The full-length protein has a reported molecular mass near 4963 Da, while material sold as TB-500 is often described as a fragment containing the actin-binding motif LKKTETQ. Because suppliers use the name inconsistently, published sources sometimes refer to the same label as a fragment, a synthetic copy, or a related analog. This naming ambiguity complicates direct comparison of reports across studies.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
Lyophilised peptide powders are hygroscopic, and the fragment absorbs atmospheric moisture when a vial is opened at room temperature. Weighing and aliquoting are normally done quickly in a dry environment, and stock solutions are divided into single-use portions before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and can shift the measured content of a vial. These practices are general to synthetic peptides rather than unique to this sequence, but they matter more for short chains kept for long periods.
| Property | Value | Notes |
|---|---|---|
| Molecular mass | Approximately 4963 Da for full-length thymosin beta-4 | Value applies to the parent protein; fragment products may differ |
| Appearance | White to off-white lyophilized powder | Typical form of supplied synthetic peptide |
| Solubility | Freely soluble in water | Polar peptide; dissolves readily in aqueous buffer |
| Storage of dry powder | −20 °C, desiccated, protected from light | Standard laboratory practice for peptides |
| Typical detection method | Liquid chromatography–tandem mass spectrometry | Used in purity testing and anti-doping analysis |
Detection in biological matrices generally relies on liquid chromatography coupled with tandem mass spectrometry, because the peptide lacks a convenient ultraviolet chromophore beyond the amide backbone. Immunoassays have been described, but antibodies raised against the fragment can cross-react with the full-length protein or with unrelated peptides, so findings usually require confirmation by a second technique. Sample preparation typically involves protein precipitation followed by solid-phase extraction. Reported detection windows depend on dose, route, matrix, and instrument sensitivity.
Lyophilised material is stable for extended periods when kept dry and cold, and suppliers typically recommend storage well below freezing. Once dissolved, the peptide is handled at refrigeration temperatures and used within a short period, because peptide bonds and the acetylated terminus can be affected by repeated freeze-thaw cycles, proteases, or extreme pH. Bacteriostatic water and saline are both described as solvents, although preservatives can interfere with some analytical workflows. Reconstituted solutions are inspected for particulates before use.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
Purity is normally assessed by reversed-phase HPLC, with the main peak reported as a percentage of total peak area, while identity is confirmed by mass spectrometry. Electrospray and MALDI-TOF instruments are both used, and the observed mass is compared with the value calculated from the stated sequence. Ion-exchange or size-exclusion methods appear where aggregation or charge variants are of interest. Water content, counter-ion content and residual trifluoroacetate from purification are separate variables that can shift the measured mass and should be weighed when reading a certificate of analysis.
The compound is most often distributed as a lyophilized powder, appearing white to off-white and forming a loose cake or fluffy solid. It is hygroscopic to some degree, so brief exposure to humid air can add water weight and complicate weighing. The peptide dissolves readily in water and in neutral aqueous buffers, and aqueous solubility is generally described as high, well above the concentrations used in typical assays. Some polar organic solvents are also usable, which matters when a concentrated stock is prepared before dilution into buffer.
Storage recommendations center on keeping the dry powder cold, dry, and dark. A freezer at -20 degrees Celsius or below is conventional, and desiccant is often included to limit moisture uptake. Once dissolved, the peptide is less stable, and solutions are typically kept frozen and thawed only once. Repeated freeze-thaw cycles are a common source of losses because they promote aggregation and adsorption to container surfaces. Working aliquots are therefore prepared in advance, and glass or low-binding plastic is usually preferred over ordinary laboratory plastic.
==== African plate ==== Mount Etna (47) 37°45′N 15°00′E Hoggar hotspot (13) 23°18′N 5°36′E, w= 0.3 az= 046° ±12° Tibesti hotspot (40) 20°48′N 17°30′E, w= 0.2 az= 030° ±15° Jebel Marra/Darfur hotspot (6) 13°00′N 24°12′E, w= 0.5 az= 045° ±8° Afar hotspot (29, misplaced in map) 7°00′N 39°30′E, w= 0.2 az= 030° ±15° rate= 16 ±8 mm/yr Possibly related to the Afar triple junction, 30 Ma. Cameroon hotspot (17) 2°00′N 5°06′E, w= 0.3 az= 032° ±3° rate= 15 ±5 mm/yr Madeira hotspot (48) 32°36′N 17°18′W, w= 0.3 az= 055° ±15° rate= 8 ±3 mm/yr Canary hotspot (18) 28°12′N 18°00′W, w= 1 az= 094° ±8° rate= 20 ±4 mm/yr New England/Great Meteor hotspot (28) 29°24′N 29°12′W, w= 0.8 az= 040° ±10° Cape Verde hotspot (19) 16°00′N 24°00′W, w= 0.2 az= 060° ±30° Sierra Leone hotspot St. Helena hotspot (34) 16°30′S 9°30′W, w= 1 az= 078° ±5° rate= 20 ±3 mm/yr Gough hotspot (49), at 40°19' S 9°56' W. 40°18′S 10°00′W, w= 0.8 az= 079° ±5° rate= 18 ±3 mm/yr Tristan hotspot (42), at 37°07′ S 12°17′ W. 37°12′S 12°18′W Vema hotspot (Vema Seamount, 43), at 31°38' S 8°20' E. 32°06′S 6°18′W Related maybe to the Paraná and Etendeka traps (c. 132 Ma) through the Walvis Ridge. Discovery hotspot (50) (Discovery Seamounts) 43°00′S 2°42′W, w= 1 az= 068° ±3° Bouvet hotspot (51) 54°24′S 3°24′E Shona/Meteor hotspot (27) 51°24′S 1°00′W, w= 0.3 az= 074° ±6° Réunion hotspot (33) 21°12′S 55°42′E, w= 0.8 az= 047° ±10° rate= 40 ±10 mm/yr Possibly related to the Deccan Traps (main events: 68.5–66 Ma) Comoros hotspot (21) 11°30′S 43°18′E, w= 0.5 az=118 ±10° rate=35 ±10 mm/yr
==== Hodgkin-Huxley Model ==== The Hodgkin–Huxley model translates data about the current of a system at a specific voltage into time-dependent data describing the membrane potential. Experiments using this model typically rely on the same format and assumptions, but vary the differential equations to answer their particular questions. Much has been learned about vasopressin, GnRH, somatotrophs, corticotrophs, and lactotrophic hormones by employing this method.
== Stimulants == A stimulant is defined as an agent (as a drug) that temporarily increases the activity central nervous system and the body. For athletes, stimulants are used for two major reasons: to heighten energy levels and to boast endurance. Examples of stimulants are: amphetamine (Adderall), caffeine (guarana), cocaine, ephedrine, fenfluramine (Fen), methamphetamine, methylphenidate (Ritalin), phentermine (Phen), synephrine (bitter orange). Stimulants phenylephrine and pseudoephedrine aren't banned. The most common abused stimulant by athletes is amphetamine.
== Research uses == As an analog of L-phenylalanine, azidophenylalanine is incorporated into proteins during translation in place of phenylalanine. The azide group enables bioorthogonal reactions, such as copper-catalyzed or strain-promoted azide-alkyne cycloadditions, for protein modification. Azidophenylalanine is employed in metabolic labeling to detect nascent protein synthesis as a non-radioactive alternative to traditional methods. It facilitates site-specific protein labeling for microscopic imaging, purification, and FRET studies. Applications include photochemical control of fluorescent proteins, synthesis of ligands for metal complexation in EPR/NMR, and probing protein dynamics during folding or catalysis. It is incorporated using orthogonal tRNA/synthetase pairs in systems like E. coli.
Sources: en.wikipedia.org
In peptoids, the side chain is connected to the nitrogen of the peptide backbone, instead of the α-carbon as in peptides. Notably, peptoids lack the amide hydrogen which is responsible for many of the secondary structure elements in peptides and proteins. Peptoids were first invented by Reyna J. Simon, Ronald N. Zuckermann, Paul Bartlett and Daniel V. Santi to mimic protein/peptide products to aid in the discovery of protease-stable small molecule drugs for the East Bay company Chiron. Following the sub-monomer protocol originally created by Ron Zuckermann, each residue is installed in two steps: acylation and displacement. In the acylation step, a haloacetic acid, typically bromoacetic acid activated by diisopropylcarbodiimide reacts with the amine of the previous residue. In the displacement step (a classical SN2 reaction), an amine displaces the halide to form the N-substituted glycine residue. The submonomer approach allows the use of any commercially available or synthetically accessible amine with great potential for combinatorial chemistry.
By the 1801 Treaty of Lunéville, the last Este Duke was compensated with the Breisgau region of the former Further Austrian territories in southwestern Germany, and died in 1803. Following his death, the claims to the no longer existing ducal crown of Modena were inherited by his son-in-law, the Habsburg-Lorraine Archduke Ferdinand of Austria, an uncle of Emperor Francis II.
=== Dextran microsphere applications === Dextran-based microspheres can encapsulate a variety of drugs and provide therapeutic delivery in the treatment of diseases such as cancer, colonic diseases, bone diseases, and cardiovascular diseases.
Sources: en.wikipedia.org
Not necessarily. TB-500 is a commercial label that suppliers apply to synthetic peptides described as thymosin beta-4 or a fragment of it. Published research most often studies the full-length protein, so statements about one do not automatically transfer to the other.
No. No major regulatory authority lists an approved product under this name, and no pharmacopoeial monograph exists for it. Material sold under the label is therefore supplied outside approved pharmaceutical channels, which affects the quality documentation available.
It falls within a prohibited class covering peptide hormones and growth factors, based on presumed effects on tissue repair and blood vessel formation. Anti-doping laboratories have published mass spectrometry methods for detecting thymosin beta-4 related peptides in urine samples.
Divide it into single-use aliquots and hold them frozen at -20 °C or below, protected from light. Repeated thawing of one container is the main avoidable source of variability.